Andy Johnson - All Kind of Welding Solutions

How Air-Acetylene Welding Works: Practical Guide

Torch lit, soft yellow flame hissing, and the metal warming up slower than it would with oxy-acetylene—that’s usually someone working […]

Trigger pulled, motor humming, but the wire jerks… stops… then suddenly spits out in a tangled mess. I’ve dealt with

Torch flame steady, stainless joint heating slowly, and the bronze rod just starting to flow—that’s a moment where patience really

Tungsten poised, foot pedal ready, and the arc ignites smoothly without a spark—that’s lift TIG welding in action. I’ve used

Arc glowing bright, tungsten inches from your fingers, and heat building up on a small stainless joint—that’s TIG welding at

Gun in hand, sparks flying harder than usual, and slag covering the bead—that’s the first thing most welders notice when

Thin sheet clamped down, heat building fast, and suddenly you’ve blown a hole right through the panel—that’s the reality of

Arc running hot, travel speed just a little too fast, and suddenly you notice a groove carved along the edge

Everything looks fine when you finish the weld—clean bead, solid penetration, no visible defects. Then the next morning, a fine

Fresh bead laid down, slag chipped off, and that solid steel joint cooling in front of you—that’s when the real